Solutions to the problem of the interruption signal to the satellite No Signal

حلول مشكلة إنقطاع إشارة الأقمار الصناعية No Signal

A lot happens to stop that satellite from the work of the absence of things, the sudden interruption of her arrival from the dish to the fee available to students may surprise some about the access into a week.
Here are some of the solutions mate do steps such as communicate and call a technician to satelite.

It is the day when the inhabitants of this planet to the stuff coming from the moon is Artificial to weaken the certainty and according to the weather condition and the purity of the procedure and the obstacles that operate on a drop in the quality of that stuff, in the days cloudy and weaken the power of stuff and no I was in the sky clouds hovering over carry the intentions of the forgiving snow.

Cut the image gradually down to the “kernel signal”

The words no signal No Signal that may suddenly appear other than they appear by prior arrangement , subject to it, if you relay the broadcast in a net of pure begin with, this picture is fracking bit by bit to just disappear and with them a message of NO SIGNAL in so doing be sure that it’s a common occurrence when many loss the stuff here coincide, and weather the height of the size of the barriers between the moon and the.

Low signal strength is inevitable. but the difference between your case and the status of others that they could follow the broadcast while stopped at … is the power of stuff and treaties of the dish prior, there is a large difference in to be the strength of the signals received by the dish and is 90% and I use it in the best conditions by 65% !

In the first case, I thinned the stuff about 90% of the bad air condition will drop to 70 or 60%, which is sufficient to receive the channels without problems and without chopping.
But if signal strength in best conditions by 65% and the change of weather conditions told The Clouds and the wind will drop those things without the 40% to start off with the image in the fracking to stop completely until the return of weather to an earlier era.

The solution in such a situation

You will need to re adjust the dish and down to the best and strongest signal can be independence in your area so that you avoid the audio stop when you drop those things, for whatever reason.
It is expected to use a cup of the satellite to the end unless you’re a rebel in this regard.

The interruption of the image suddenly No Signal

  • Unlike the first case, in this case the things are high end and suddenly appear the message the lack of No Signal.
  • Steps to suffer the above two cases follow :
  • You must make sure that the dish in the place is completely devoid of obstructions like walls and trees that their branches and to be the distance between the dish and nearest obstacle 8 meters.
  • Units reduce noise “pickup LNB” operate with high efficiency when the single serving site one. Those that serve 2 or 4 receivers perishables may be the cause of the appearance of a message of No Signal suddenly to the malfunction of this unit, with reference to that unit LNB single, Don’t tell from those problems but they live longer.
  • When you receive the message No Signal suddenly , working on the verification of the constancy of the dish and not damage due to wind.

  • Be sure to put the unit to the LNB in receiver LNB Power, then I put it ON, screw around a lot in these holidays for the purposes of trade, from the On position to the Off you might know him for.
    Don’t forget that most of those ingredients come from China !!
  • If you’re someone who depends entirely on the diet you receive from more than one satellite , make sure the absence of trees on the rest of the satellites, in the case of the loss of the stuff on the moon is only one, work to change the entrance to this moon of the diet you promising to adjust the port number through the settings of the drawing available.
  • Check out the link to the RF Connector that connect to and LND and it’s okay to change it with another better “buffer” after scanning a vertical antenna which metal will contact with the RF Connector .

Prefer to work to change the link to my RF Connector those that call and those that call Denver after work on the story of the top wire of new.

Make sure the cable from the intermittency in the case of his condition was that bad. we replaced the latest new and the above price per metre.

In many cases you may have to re-adjust the drawing to prepare his default when managed to improve signal strength .. and go was always b drawing available which between your hands is not from the industry of Germany or the UK.
May be science is not in the dish or satellite or even Wire.

To talk rest ..

Solutions to the problem of the interruption signal to the satellite No Signal

Leave a Reply

Your email address will not be published. Required fields are marked *